I In drilling, the process of lifting the drill cuttings from the bottom of thedrill hole to the surface requires the selection of the appropriate sludge so that theremoval of the drill cuttings can run optimally. In the analysis of the removal ofdrill cuttings begins with the calculation of several parameters, namely, thecalculation of the value of the power law index and the calculation of the power lawconstant, the value of the calculation will be used as a reference in calculating thevalue of the KCCI, the value of the mud velocity on the annulus and the speed of themud slip . The successful removal of drill cuttings is related to the parameters of thesludge used. There are several parameters of sludge used including, density,viscosity, plastic viscosity, and yield point. Therefore, a good sludge compositionwill greatly determine the success of a drilling activity in a well. If the ability to liftdrill cuttings by drilling mud is poor, it will have a significant impact, such as apinched pipe or a sheath pipe that cannot be placed properly. The calculation usedin the analysis of removal of this drill cuttings is the cutting carrying index methodobtained an average value of 2.4%, then for the method of cutting transport ratioobtained an average value of 95.57% and the method of cutting concentration inannulus with the success of an average value 1.69% for each temperature. With thesuccessful removal of drill cuttings to the surface, drilling operations can also besaid to be successful.d